Network Port Leds; Jrr200 Route Reflector Chassis Rear Panel; Figure 3: Network Port Leds; Figure 4: Jrr200 Route Reflector Rear Panel - Juniper JRR200 Hardware Manual

JRR200 Route Reflector Hardware Guide

JRR200 Route Reflector Chassis Rear Panel

20

Network Port LEDs

Each SFP+ port has two status LEDs located above the port.
the LEDs. Figure 3 on page 20

Figure 3: Network Port LEDs

Table 6: Network Port LEDs

Callout LED
1 Link (LED on the
left)
2 Speed/Activity
(LED on the
right)
Figure 4 on page 20 shows the rear panel of the JRR200 Route Reflector.
Table 7 on page 20 lists and describes the rear panel components.

Figure 4: JRR200 Route Reflector Rear Panel

Table 7: JRR200 Route Reflector Rear Panel Components

Number Component
1 Grounding point
2 Power switch
shows the LEDs.
Description
Solid green—There is link activity.
Off—There is no link established.
Solid amber—10G/1G link is established.
Blinking amber—There is activity on the 10G/1G link.
Off—There is no link established.
Description
Connects the JRR200 route reflector chassis to earth ground.
Use the Power switch to power on or power off the JRR200 route
reflector.
Copyright © 2018, Juniper Networks, Inc.
Table 6 on page 20 describes