Table of Contents
Advertisement
Caption
Color
SIM1
Yellow
SIM2
Yellow
Table 4:
Router Status Indication
a. The WAN status is updated every 10 seconds. The WAN LED displays the current status.
3.5.2
Power Connector
Panel socket 2-pin.
Pin number
Signal mark
1
VCC(+)
2
GND(-)
Table 5:
Connection of Power Connector
Figure 10: Power connector
The power supply for the router should be between +12 V to +24 V DC
supply. Protection against reversed polarity without signaling is built into the
router.
The power consumption during receiving is 2.3 W. The peak power
consumption during data sending is 5.5 W. For correct operation, it is
necessary that the power source is able to supply a peak current of 0.9 A.
Circuit example:
Figure 11: Power connector pin-outs
3.5.3
Grounding the device (functional earth)
Ground the device by connecting the minus pole (GND) of the power supply
to earth. When you mount the device on a grounded DIN rail, then the DIN
rail provides the ground.The shield of a shielded twisted pair cable is
connected to the housing and the minus pole of the power supply socket.
20
State
Description
On
SIM card 1 is active
On
SIM card 2 is active
Description
Positive pole of DC supply voltage (+12 to +24 V DC)
Negative pole of DC supply voltage (connected to ground)
Installation OWL 3G
Release 3 06/2017
Advertisement
Table of Contents
