Signal I/O - Teledyne 200E Instruction Manual

Operating Instructions
To access the DIAG functions press the following keys:
SAMPLE
< TST TST > CAL
EXIT returns
SETUP X.X
to the main
SAMPLE
CFG DAS RNGE PASS CLK
display
EXIT returns
SETUP X.X
to the PRIMARY
SETUP MENU
COMM VARS
From this point
SETUP X.X
forward, EXIT returns
to the
SECONDARY
SETUP MENU
DIAG
NEXT
DIAG
PREV

6.7.1. Signal I/O

The signal I/O diagnostic mode allows to review and change the digital and analog
input/output functions of the analyzer. See Appendix A-4 for a complete list of the
parameters available for review under this menu.
Any changes of signal I/O settings will remain in effect only until the signal I/O
menu is exited. Exceptions are the ozone generator override and the flow sensor
calibration, which remain as entered when exiting.
58
RANGE = 500.0 PPB
PRIMARY SETUP MENU
MORE
SECONDARY SETUP MENU
DIAG
ENTER DIAG PASS: 818
8 1 8
SIGNAL I / O
ENTR
ANALOG OUTPUT
NEXT ENTR
Model 200E Instruction Manual
NOX=X.X DIAG
SETUP PREV
DIAG
PREV
EXIT
DIAG
PREV
EXIT
DIAG
PREV
ENTR EXIT
DIAG
PREV
EXIT
DIAG
EXIT
PREV
NOTE
ANALOG I / O CONFIGURATION
NEXT ENTR
TEST CHAN OUTPUT
NEXT ENTR
OPTIC TEST
NEXT ENTR
ELECTRICAL TEST
NEXT ENTR
OZONE GEN OVERRIDE
NEXT ENTR
FLOW CALIBRATION
NEXT ENTR
044100102 Rev A
EXIT
EXIT
EXIT
EXIT
EXIT
EXIT