Settings - ABB RET650 Technical Manual

Section 16
Station communication
16.11.2
Table 466: OPTICAL103 Non group settings (basic)
Name
SlaveAddress
BaudRate
RevPolarity
CycMeasRepTime
MasterTimeDomain
TimeSyncMode
EvalTimeAccuracy
EventRepMode
550
principle. The master must have software that can interpret IEC 60870-5-103
communication messages.
Function blocks available for the IEC 60870–5–103 protocol are described in sections
Control and Monitoring.The Communication protocol manual for IEC 60870-5-103
includes the 650 series vendor specific IEC 60870-5-103 implementation.
IEC 60870-5-103 protocol can be configured to use either the optical serial or RS485
serial communication interface on the COM03 or the COM05 communication
module. The functions Operation selection for optical serial OPTICALPROT and
Operation selection for RS485 RS485PROT are used to select the communication
interface.
See the Engineering manual for IEC103 60870-5-103 engineering
procedures in PCM600.
The function IEC60870-5-103 Optical serial communication, OPTICAL103, is used
to configure the communication parameters for the optical serial communication
interface. The function IEC60870-5-103 serial communication for RS485,
RS485103, is used to configure the communication parameters for the RS485 serial
communication interface.

Settings

Values (Range) Unit
1 - 255 -
9600 Bd -
19200 Bd
Off -
On
1.0 - 1800.0 s
UTC -
Local
Local with DST
IEDTime -
LinMastTime
IEDTimeSkew
Off -
5ms
10ms
20ms
40ms
SeqOfEvent -
HiPriSpont
Step Default
1 1
- 9600 Bd
- On
0.1 5.0
- UTC
- IEDTime
- 5ms
- SeqOfEvent
1MRK 504 135-UEN A
Description
Slave address
Baudrate on serial line
Invert polarity
Cyclic reporting time of measurments
Master time domain
Time synchronization mode
Evaluate time accuracy for invalid time
Event reporting mode
Technical manual