Settings; Operation Principle - ABB RET650 Technical Manual

1MRK 504 135-UEN A
12.8.5
Table 259: AUTOBITS Non group settings (basic)
Name Values (Range)
Operation
12.8.6
Technical manual
Name
CMDBIT8
CMDBIT9
CMDBIT10
CMDBIT11
CMDBIT12
CMDBIT13
CMDBIT14
CMDBIT15
CMDBIT16
CMDBIT17
CMDBIT18
CMDBIT19
CMDBIT20
CMDBIT21
CMDBIT22
CMDBIT23
CMDBIT24
CMDBIT25
CMDBIT26
CMDBIT27
CMDBIT28
CMDBIT29
CMDBIT30
CMDBIT31
CMDBIT32

Settings

Unit
Off -
On

Operation principle

Automation bits function (AUTOBITS) has 32 individual outputs which each can be
mapped as a Binary Output point in DNP3. The output is operated by a "Object 12" in
DNP3. This object contains parameters for control-code, count, on-time and off-time.
To operate an AUTOBITS output point, send a control-code of latch-On, latch-Off,
pulse-On, pulse-Off, Trip or Close. The remaining parameters will be regarded were
Type Description
BOOLEAN Command out bit 8
BOOLEAN Command out bit 9
BOOLEAN Command out bit 10
BOOLEAN Command out bit 11
BOOLEAN Command out bit 12
BOOLEAN Command out bit 13
BOOLEAN Command out bit 14
BOOLEAN Command out bit 15
BOOLEAN Command out bit 16
BOOLEAN Command out bit 17
BOOLEAN Command out bit 18
BOOLEAN Command out bit 19
BOOLEAN Command out bit 20
BOOLEAN Command out bit 21
BOOLEAN Command out bit 22
BOOLEAN Command out bit 23
BOOLEAN Command out bit 24
BOOLEAN Command out bit 25
BOOLEAN Command out bit 26
BOOLEAN Command out bit 27
BOOLEAN Command out bit 28
BOOLEAN Command out bit 29
BOOLEAN Command out bit 30
BOOLEAN Command out bit 31
BOOLEAN Command out bit 32
Step Default
- Off
Section 12
Description
Operation Off / On
Control
363