Configuring The Sending Mode Of Accounting Start Requests - H3C S3100 Series Operation Manual

Follow these steps to configure the RADIUS authorization attribute ignoring function:
To do...
Enter system view
Create a RADIUS
scheme and enter
its view
Configure the
RADIUS
authorization
attribute ignoring
function
In a RADIUS scheme, you can configure:
One standard attribute ignoring command
One proprietary attribute ignoring command per vendor
Up to three attribute ignoring commands in total

Configuring the Sending Mode of Accounting Start Requests

Table 2-13 Configure the sending mode of accounting start requests
Operation
Enter system view
Create a RADIUS scheme and
enter its view
Configure the sending mode of
accounting start requests
The sending mode of accounting start requests depends on the RADIUS server. If the RADIUS
server can perform accounting for only the accounting start requests carrying an IP address,
configure the sending mode as with-ip.
At present, a switch obtains the IP address of a requesting client through EAP or DHCP snooping.
If Upload IP address is enabled for the client using iNode client software, the client's IP address
will be sent to the switch through EAP. With DHCP snooping enabled, the switch will obtain the IP
addresses of clients using DHCP. For the detailed configuration of DHCP snooping, refer to DHCP
Operation of this manual.
Use the command...
system-view
radius scheme
radius-scheme-name
attribute-ignore { standard |
vendor vendor-id } type type-value
system-view
radius scheme
radius-scheme-name
accounting start-mode
{ with-ip | without-ip }
2-15
—
Required
By default, a RADIUS scheme named
"system" has already been created in
the system.
Required
Disabled by default.
Command
Remarks
Remarks
—
—
Required
without-ip by default.