No Syslogserver - Siemens SCALANCE W770 Series Configuration Manuals

Result
The settings for the Syslog server are configured. The Syslog server was entered in the table.
Further notes
You delete the entry with the no syslogserver command.
You can display the status of this function and other information with the show events
config command.
You store a domain name with the ip domain name or domain name command.
12.2.2.2

no syslogserver

Description
With this command, you delete a Syslog server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no syslogserver { ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6
<ip6_addr>}
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
ipv6
ip6_addr
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Keyword for an IPv4 address
IPv4 unicast address of the Syslog serv‐
er
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
IPv6 address of the Syslog server
Diagnostics
12.2 Syslog client
Range of values / note
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
-
Enter a valid IPv6 address.
605