No Wlan Any Ssid (Client) - Siemens SCALANCE W770 Series Configuration Manuals

See also
no wlan any ssid (client) (Page 225)
vap broadcast ssid (access point) (Page 266)
7.1.5.19

no wlan any ssid (client)

Description
With this command, you disable the "Any ssid" function. The client attempts to connect to the
access point from the SSID list that provides the best transmission quality and on which the
"Broadcast SSID" option is disabled.
Note
This command is only available in the client mode.
Requirement
● An active SSID is available.
You are in the Interface configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan any ssid
Result
The function is disabled.
Further notes
You display the setting with the show wlan client <wlan 0/X> command.
You enable the function with the wlan any ssid command (default setting).
See also
wlan any ssid (Client) (Page 224)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.1 WLAN
225