Belt Maintenance; Checking The Condition Of The Hydraulic Pump Belt; Checking The Alternator/Fan Belt Tension; Controls System Maintenance - Toro 22323G Operator's Manual

Belt Maintenance

Checking the Condition of the
Hydraulic Pump Belt
Service Interval: Yearly
Check the condition of the hydraulic pump belt (Figure 50)
yearly. Have an Authorized Service Dealer replace it if it
becomes damaged or worn.
Figure 50
1. Hydraulic pump belt
Checking the Alternator/Fan
Belt Tension
Service Interval: Every 100 hours—Check the alternator/fan
belt tension (refer to the Engine Operator's
Manual for instructions).
Every 500 hours—Replace the alternator/fan belt
(refer to the Engine Operator's Manual for instructions).
Controls System
Maintenance
The factory adjusts the controls before shipping the traction
unit. However, after many hours of use, you may need to
adjust the traction control alignment, the neutral position of
the traction control, and the tracking of the traction control
in the full forward position.
Important: To adjust the controls properly, complete
each procedure in the order listed.
Adjusting the Traction Control
Alignment
If the traction control bar does not rest flush and square
with the reference bar when in the full backward position,
immediately complete the following procedure:
1. Park the traction unit on a flat surface and lower the
loader arm.
2. Stop the engine and remove the key.
3. Pull straight back on the traction control so the front
of the control contacts the reference bar (Figure 51).
1. Front of the control, out of
alignment
4. If the front of the traction control does not rest square
and flush with the reference bar, loosen the flange nut
and bolt in the stem of the traction control (Figure 52).
1. Traction control
40
Figure 51
2. Reference bar
Figure 52
2. Stem, bolt, and nut