Keyless Entry Transmitter; Standard Procedure - Transmitter; Programming; Specifications - Chrysler 300M 2002 Service Manual

8N - 6 POWER LOCKS
DOOR LOCK SWITCH (Continued)
DOOR LOCK SWITCH CONTINUITY
SWITCH CONTINUITY
POSITION BETWEEN
LOCK 1 AND 4
UNLOCK 1 AND 4
KEYLESS ENTRY

TRANSMITTER

STANDARD PROCEDURE - TRANSMITTER

PROGRAMMING

The Remote Keyless Entry (RKE) Transmitter(s)
can be programmed with the use of the DRB III
scan tool, or by the customer.
PROGRAMMING TRANSMITTER WITH THE DRB
III SCAN TOOL
For procedures on programming the transmitter(s)
with the DRB III scan tool, refer to the proper Body
Diagnostic Procedures Manual.
PROGRAMMING BY CUSTOMER
For a customer to be able to program RKE trans-
mitters themselves, at least one RKE transmitter
must be programmed already. This procedure is to
add additional transmitters. If all transmitters are
lost, the DRB III scan tool must be used to program
the new transmitter(s).
Transmitter programming by the customer is done
by continually pressing the unlock button, on a pro-
grammed fob, for a minimum of 4 seconds to a max-
imum of 10 seconds with the ignition switch ON.
Within the 4-10 second range, the panic button is
depressed. Both buttons are then released.
The BCM will chime. Them press any button on
each fob to be programmed. The BCM will chime as
each fob is learned. To exit program mode, turn off
ignition or wait 32 seconds. The BCM will chime
again.

SPECIFICATIONS

TRANSMITTER
RESISTANCE
VALUE
BATTERY
2700 ± 10%
The transmitter has two 3 volt batteries, which can
620 ± 10%
be removed and replaced without special tools. Insert
a dime in the side slot of the transmitter and twist.
the halves should separate and the batteries are
stacked on top of each other. The batteries are avail-
able at local retail stores. Recommended batteries are
Panasonic CR 2016 or equivalent. Battery life is
about two years (Fig. 1).
RANGE
Operation range is within 12 meters (40 ft.) of the
module/receiver.
REMOTE KEYLESS ENTRY
MODULE
REMOVAL
The Remote Keyless Entry (RKE) Module is
located between the junction block and body control
module. Refer to Electrical, Electronic Control Mod-
ules, Body Control Module, Removal.
(1) Disconnect and isolate the battery negative
cable.
(2) With the junction block/BCM removed, sepa-
rate the two by removing the four retaining screws.
(3) Unsnap the RKE module from the BCM.

INSTALLATION

(1) Place module into position on BCM and snap
the RKE Module into place.
(2) Attach the junction block/BCM and install the
four retaining screws.
(3) Connect battery negative cable.
Install the BCM. Refer to Electrical, Electronic
Control Modules, Body Control Module, Installation.
NOTE: The RKE transmitters must be repro-
grammed to the new RKE module.
LH