Remote Keyless Entry (Rke) Module; Traction Control Switch; Trip Reset Knob; Upper Right Trim Bezel (Lhs / 300M) - Chrysler 2000 LHS Owner's Manual

LH
REMOVAL AND INSTALLATION (Continued)
(5) Remove cluster mask/lens from instrument
cluster. Refer to Mask/Lens Removal and Installation
in this section.
(6) Remove two screws to Vacuum Fluorescent
(VF) display Odometer and remove from cluster.
INSTALLATION
For installation, reverse the above procedures.
RADIO
Refer to Group 8F, Audio System for the proper
radio removal and installation procedures.

REMOTE KEYLESS ENTRY (RKE) MODULE

Refer to Group 8P, Power Door Locks for Remote
Keyless Entry Module Removal and Installation pro-
cedures.

TRACTION CONTROL SWITCH

The traction control switch in located in the upper
right trim bezel on the instrument panel. The upper
right trim bezel must be removed to service the
switch. Refer to Upper Right Trim Bezel Removal
and Installation in this section.
REMOVAL
(1) With the bezel removed, press the tabs in at
both sides of the switch and remove the switch from
the bezel.
INSTALLATION
For installation, reverse the above procedures.
Check the switch for proper operation.

TRIP RESET KNOB

The instrument cluster must be removed for Trip
Reset Knob service. Refer to Instrument Cluster and
Bezel Removal and Installation in this section.
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 22).
(2) Remove instrument cluster from vehicle. Refer
to procedures in this section.
INSTRUMENT PANEL SYSTEMS
(3) Remove five cluster back cover retaining
screws and remove the cover.
(4) Remove nine screws to Printed Circuit Board
and remove.
(5) Gently pull Trip Reset Knob from the instru-
ment cluster housing and remove.
INSTALLATION
For installation, reverse the above procedures.

UPPER RIGHT TRIM BEZEL (LHS / 300M)

REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 22).
(2) Using a trim stick (special tool #C-4755), gently
pry out on center instrument panel bezel.
(3) Open glove box and remove four screws along
bottom edge of trim bezel.
(4) Remove one screw in center bezel area.
(5) Loosen the lower right edge of steering column
cover, then loosen upper right corner of steering col-
umn cover.
(6) Using a trim stick, gently pry bezel away from
the instrument panel and disconnect the traction
control switch connector.
(7) Remove upper right trim bezel from vehicle.
Fig. 23 Upper Right Trim Bezel
1 – TRACTION CONTROL SWITCH
2 – UPPER RIGHT TRIM BEZEL
INSTALLATION
(1) For installation, reverse the above procedures.
8E - 17