SSANGYONG 1999 Musso Service Manual page 1233

5D2-26 TRANSFER CASE (TOD)
Stage
Check resistance of electro-magnetic clutch.
1. Disconnect 30 pin connector from TOD control unit.
2. Measure resistance between pin 3 and 7 in wiring
C3
connector using multi-tester.
- Specified value
- Measured value is within specified range?
Check operational voltage of elector-magnetic clutch.
1. Ignition "ON"
2. Measure voltge between pin 3(+) and 17(-)in TOD
C4
control unit connector.
- Specified value
- Measure value is within specified range ?
Test Stage / Contents
Test Contents and Procedure
4WD high
4WD low
Result
Countermeasure
Specified Value
/Yes/No
2.5W
Yes Perform C4 stage
No
0Vdc
11 - 15Vdc
Yes Replace TOD
control unit
No
Replace wire
0W : short
¥ W : open