Loading Paper In Tray 3 (When Tandem Tray Module Is Installed) - Fuji Xerox apeosport-iv C5570 Administrator's Manual

2 Paper and Other Media
1
Pull out the tray until it stops.
Important • While the machine is processing a job, do
2
2
Load and align the edge of the paper against
the left edge of the tray, with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
3
Push the tray in gently until it stops.
Important • When inserting the tray, push it gently. Forcibly pushing the tray in may cause machine

Loading Paper in Tray 3 (When Tandem Tray Module is Installed)

The following describes the procedure for loading paper in Tray 3 when the Tandem
Tray Module is installed.
When the machine runs out of paper during copying or printing, a message appears on
the touch screen. Add paper according to the message instructions. Copying or printing
automatically resumes when paper is added.
Note
For information on changing the paper size and orientation, refer to "Changing the Paper Size for Tray 3
(When Tandem Tray Module is Installed)" (P.49).
44
not pull out the tray that is being used for
the job.
• To prevent paper jams or erroneous
detection of loaded paper in a tray by the
machine, do not add paper on top of any
remaining paper in the tray. Remove any
remaining paper in the tray, and then load
that paper on top of the newly loaded
paper.
• Do not pull out all the trays at the same
time. Otherwise, the machine gets
inclined and turns over, which may cause
injuries.
line ("MAX" in the right figure). It may
cause paper jams or machine
malfunction.
• Do not place any paper or objects in the
empty space on the right side of Trays 1
to 4. It may cause paper jams or machine
malfunction.
malfunction.
• Carefully fan the paper before loading it in a tray. Otherwise, the paper may stick together,
resulting in paper jams.