Connecting Cables To The Expansion Card - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Secure InfiniBand cards with one M3 x 4.5 mm screw each.
I
In case of all other standard expansion cards, fixation with the locking
bar is sufficient.
Ê Insert (1) and close the PCI slot bracket locking bar (2) until the latch locks
in place (see close-up).
Ê If applicable, install SFP+ transceiver modules into the new expansion card.
9.2.1.5

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
overviews" on page
9.2.1.6 Connecting a backup unit to the expansion card
Ê If applicable, connect a BBU or FBU to the expansion card as described in
sections "Installing a BBU" on page 435
9.2.1.7 Concluding steps
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the mains" on page 118
Ê
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page 138.
"Enabling SVOM boot watchdog functionality" on page 146
Ê
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task:
356
738.
"Updating RAID controller firmware" on page
"Resuming BitLocker functionality" on page 152
Upgrade and Maintenance Manual
or "Installing an FBU" on page
"Enabling Option ROM scan" on
TX300 S8 / RX350 S8
"Cabling
440.
137.