Installing An Expansion Card; Connecting Cables To The Expansion Card; Connecting A Backup Unit To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Remove the defective expansion card as described in section
expansion cards" on page
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
page 204.
9.4.3.3

Installing an expansion card

Ê If applicable, install a slot bracket on the new expansion card as described
in section "Installing a slot bracket" on page
Ê Install the new expansion card as described in section
cards" on page
Ê If applicable, reinstall SFP+ transceiver modules on the new expansion
card, as described in section
page 205.
9.4.3.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
plans" on page
9.4.3.5

Connecting a backup unit to the expansion card

Ê If applicable, connect a BBU or FBU to the expansion card as described in
sections "Installing a BBU" on page 224
9.4.3.6

Concluding steps

"Reassembling" on page 64
Ê
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the mains" on page 74
Ê
"Enabling replaced components in the system BIOS" on page 95
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 101.
"Updating the NIC configuration file in a Linux environment" on page 99
Ê
220
215.
211.
"Installing SFP+ transceiver modules" on
405.
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
"Removing a slot bracket" on
200.
"Installing expansion
or "Installing an FBU" on page
"Removing
"Cabling
229.
TX150 S8 / TX200 S7