Expansion cards and backup units
Figure 84: Installing the expansion card (B)
Ê Fasten the expansion card with the screw.
Ê If applicable, install SFP+ transceiver modules into the new expansion card,
as described in section
9.2.1.5
Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
overview" on page
9.2.1.6
Connecting a battery backup unit to the expansion card
Ê If applicable, connect a BBU to the expansion card as described in section
"Installing a BBU" on page
9.2.1.7
Concluding steps
Perform the following procedures:
"Installing the air duct" on page 74
Ê
194
"Installing SFP+ transceiver modules" on page
525.
227.
Upgrade and Maintenance Manual
262.
"Cables
RX300 S7