Installing An Expansion Card; Connecting Cables To The Expansion Card; Connecting A Battery Backup Unit To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX2520 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
page 184.
9.3.3.3

Installing an expansion card

Ê If applicable, "Installing a slot bracket" on page
"Installing expansion cards" on page
Ê
Ê If applicable, "Installing SFP+ transceiver modules" on page
9.3.3.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
cables" on page
9.3.3.5

Connecting a battery backup unit to the expansion card

Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page
9.3.3.6

Concluding steps

"Reassembling" on page 59
Ê
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the power source" on page 64
Ê
"Switching on the server" on page 66
Ê
"Enabling replaced components in the system BIOS" on page 87
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 94.
"Updating RAID controller firmware" on page 79
Ê
"Enabling SVOM boot watchdog functionality" on page 87
Ê
"Enabling BitLocker functionality" on page 93
Ê
190
393.
198.
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
"Removing the slot bracket" on
177.
183.
212.
"List of used
RX2520 M1