Expansion cards and backup units
9.4.3.2
Removing an expansion card
Ê Remove the expansion card as described in section
expansion card" on page
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card as described in section
on page
190.
9.4.3.3
Installing an expansion card
Ê If applicable, install the slot bracket as described in section
bracket" on page
Ê Install the expansion card as described in section
card" on page
9.4.3.4
Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I
For the cable plan see section
9.4.3.5
Concluding steps
Ê Install the corresponding riser module as described in section
riser module" on page
"Reassembling" on page 60
Ê
Ê If applicable, connect external cables to the expansion card.
"Connecting the power cord" on page 64
Ê
"Switching on the server" on page 66
Ê
"Enabling replaced components in the system BIOS" on page 90
Ê
Ê Inform the customer about changed WWN and MAC addresses, see
"Looking up changed MAC / WWN addresses" on page
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 94
"Updating expansion card firmware" on page 82
Ê
"Resuming BitLocker functionality" on page 95
Ê
202
199.
188.
198.
68.
Upgrade and Maintenance Manual
"Removing the
"Removing a slot bracket"
"Installing the expansion
"Cabling plans" on page
"Installing a slot
312.
"Installing a
97.
RX1330 M3