Removing An Expansion Card; Installing An Expansion Card; Connecting Cables To The Expansion Card; Connecting A Battery Backup Unit To The Expansion Card - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

Expansion cards and backup units
8.4.3.2

Removing an expansion card

Ê If applicable, "Removing an SFP+ transceiver module" on page
"Removing expansion cards" on page 258
Ê
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
page 248.
8.4.3.3

Installing an expansion card

Ê If applicable, "Installing a slot bracket" on page
"Installing an expansion card" on page
Ê
Ê If applicable, "Installing SFP+ transceiver modules" on page
8.4.3.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
cables" on page
8.4.3.5

Connecting a battery backup unit to the expansion card

Ê If applicable, connect an FBU cable to the expansion card as described in
section "Connecting the FBU to the RAID controller" on page
8.4.3.6

Concluding steps

"Reassembling" on page 73
Ê
Ê Connect all external cables to the replaced expansion card.
"Connecting the power cord" on page 79
Ê
"Switching on the server" on page 82
Ê
"Enabling replaced components in the system BIOS" on page 115
Ê
Ê If applicable, inform the customer about changed WWN and MAC
addresses. For further information, refer to section
MAC / WWN addresses" on page
Ê If applicable,"Updating RAID controller firmware" on page
262
559.
122.
Upgrade and Maintenance Manual
"Removing a slot bracket" on
243.
256.
"Looking up changed
252.
249.
"List of used
318.
106.
RX2540 M2