Side Gear Case - Honda NSA700A DN-1 2009 Service Manual

FINAL DRIVE
Apply 2 g (0.07 oz) or more of molybdenum
disulfide grease to the pinion jo in t splines.
Install the drive shaft into the pinion joint until the
Make sure the
stopper ring seats in the pinion jo in t spline groove.
stopper ring is
seated properly by
pulling on the drive
shaft lightly.
Be careful not to
damage the drive
shaft oil seal.
Apply 1 g (0.04 oz) of molybdenum disulfide grease
to the universal jo in t side splines of the drive shaft.
Insert the final drive assembly into the swingarm
and align the drive shaft splines w ith the universal
jo in t splines.
Install the gear case mounting nuts.
Tighten the gear case m ounting nuts in a crisscross
pattern in several steps.
TORQUE: 44 N m (4.5 kgf-m, 32 Ibf ft)
Install the rear wheel (page 16-6).
Fill the gear case with the recommended final drive
gear oil (page 4-18).

SIDE GEAR CASE

Representation of the side gear case assembly:
14-22
PINION JOINT
DRIVE SHAFT
DAMPER CAM
NUTS