Honda NSA700A DN-1 2009 Service Manual page 351

BEARING REPLACEMENT
N/D CLUTCH BEARING
Remove the N/D clutch hydraulic pipe (page 11-70).
Remove the N/D clutch bearing using the special
tools.
TOOLS:
Remover handle
Bearing remover, 20 mm
Remover weight
Coat a new bearing with engine oil.
Drive a new bearing into the right crankcase cover
w ith the marked side facing up until it is fully
seated.
TOOLS:
Driver
A ttachm ent 42 x 47 mm
Pilot, 20 mm
Install the N/D clutch hydraulic pipe (page 11-74).
HFT SHAFT BEARING
Remove the HFT shaft hydraulic pipe (page 11-71).
Remove the HFT shaft bearing using the special
tools.
TOOLS:
Remover handle
Bearing remover, 20 mm
Remover weight
Coat a new bearing w ith engine oil.
Drive a new bearing into the right crankcase cover
w ith the marked side facing up until it is fully
seated.
TOOLS:
Driver
A tta c h m e n t, 4 2 x 4 7 m m
Pilot, 20 mm
Install the N/D clutch hydraulic pipe (page 11-73).
BEARING REMOVER
07936-3710100
07936-3710600
07741-0010201 or
HANDLE
07936-371020A
(U.S.A. only)
07749-0010000
07746-0010300
07746-0040500
ATTACHMENT/PILOT
BEARING REMOVER
07936-3710100
07936-3710600
HANDLE
07741-0010201 or
0 7 9 3 6 37102 0A
(U.S.A. only)
07749-0010000
077 46-0010300
07746-0040500
ATTACHMENT/PILOT
N/D CLUTCH
BEARING
l WEIGHT
N/D CLUTCH
BEARING
HFT SHAFT BEARING
WEIGHT
HFTSHAFT
/ BEARING
HFT
11-75