Table of Contents
Advertisement
___________________________________________________________________ HFT
NEUTRAL INDICATOR
If the HFT is neutral position but the neutral indica
tor does not come on when the ignition switch is
ON and engine stop switch "O", check as follows:
NOTE:
• Check the combination meter power ground line
before troubleshooting(page 22-9).
1. Neutral
Indicator Signal Line Open
Inspection
Turn the ignition switch OFF.
Disconnect the TCM 33P (Black) connector (page
11-17).
Turn the ignition switch ON and engine stop
switch "O".
Measure the voltage between the TCM 33P
(Black) connector and ground.
Connection: A13 (+) - Ground (-)
Is there b a tte ry vo lta g e ?
YES
- Replace the TCM with a new one, and
recheck (HFT initialization procedure:
page 11-93).
NO
- Open circuit in Light green/red wire
Circuit
Advertisement
Table of Contents
Troubleshooting
