Honda NSA700A DN-1 2009 Service Manual page 225

ENGINE REMOVAL/INSTALLATION____________
Disconnect the CKP sensor 2P (Red) connector.
Disconnect the fo llo w ing :
- Neutral/drive solenoid 2P (Black) connector
- Lock up solenoid 2P (Gray) connector
- Oil pressure sensor 3P (Black) connector
Remove the bolt and disconnect the neutral sw itch
wires.
Release the w ires fro m the clamp.
Disconnect the EOT sw itch 2P (Black) connector and
swash plate angle sensor 3P (Brown) connector.
Remove the b olt and disconnect the oil pressure
sw itch w re.
8-6
2P (RED) CONNECTOR
2P (BLACK)
CONNECTOR
CLAMP
2P (GRAY)
CONNECTOR
3P (BROWN) CONNECTOR
2P (BLACK) CONNECTOR
BOLT/NEUTRAL
SWITCH WIRES
3P (BLACK)
CONNECTOR
BOLT/OIL PRESSURE
SWITCH WIRE