Pinion Gear Bearing/Shim Replacement; Case Bearing Replacement; Ring Gear Bearing - Honda NSA700A DN-1 2009 Service Manual

PINION GEAR BEARING/SHIM
REPLACEMENT
Pull the pinion gear bearing from the shaft w ith a
commercially available bearing puller.
Remove the pinion gear shim.
Select the replacement shim (page 14-10)
Install the shim and a new bearing onto the pinion
gear.
Drive a new bearing w ith the marked side facing up.
TOOLS:
Driver, 40 mm I.D.
Attachment, 25 mm I.D.

CASE BEARING REPLACEMENT

RING GEAR BEARING

Heat the gear case to 80°C (175°F) evenly using a
Be sure to wear
heat gun.
heavy gloves when
handling the heated
NOTE:
gear case.
Do not use a torch to heat the gear case; it may
cause warping.
Remove two ring gear bearings from the gear case
using the special tools.
TOOLS:
Bearing remover, 30 mm
Remover handle
Remover weight
i
PINION GEAR
07746-0030100
07746-0030200
BEARING REMOVER
07936-8890300
07936-3710100
07741-0010201 or
07936-371020A
{U.S.A. only)
BEARING/SHIM
SHIM
WEIGHT
HANDLE
FINAL DRIVE
DRIVER
ATTACHMENT
BEARING
14-15