Dtc 41-1 (N/D Select Switch) - Honda NSA700A DN-1 2009 Service Manual

HFT
DTC 41-1 (N /D SELECT SWITCH)
• Before starting inspection, Check fo r loose or
poor connectors on the right handlebar switch
(Gray) connector and TCM 33P (Black) connector,
then check the DTC.
1. N/D Select Switch Inspection
Turn the ignition switch OFF.
Disconnect the right handlebar switch
connector.
Check fo r continuity at :he switch side right han­
dlebar switch
each switch position.
Connection: N position:
Is th ere co n tin u ity ?
YES
NO
2. N/D Select Sw itch Input Voltage Inspection
Turn the ignition switch ON and engine stop
switch " O
Measure the voltage between the right handle­
bar switch
harness side and ground.
Connection: Black/blue (+) - Ground (-)
Does th e b a tte ry voltage exist?
YES
NO
3. N/D Select Switch Line Open Circuit Inspection
Disconnect the TCM 33P (Black) connector.
Check for continuity between the right handlebar
switch
nector of the main wire harness side.
Connection: A11 (W hite/yellow) - W hite/yellow
TOOL:
Test probe
Is the re c o n tin u ity ?
YES
NO
11-50
P (Gray) connector term inals in
6
Black/blue - W hite/yellow
D position:
Black/blue - W hite/blue
- GO TO STEP 2
- Faulty N/D select switch.
P (Gray) connector of the main wire
6
- GO TO STEP 3.
- Open circuit in Black/blue wire. If Black/
blue wire is rorm al, replace the TCM
with a new one, and recheck (HFT ini­
tialization procedure: page 11-93).
P (Gray) connector and TCM 33P con­
6
A22 (W hite/blue) - W hite/yellow
07ZAJ-RDJA110
- GO TO STEP 4.
- • Open circuit in W hite/yellow wire
• Open circuit in W hite/blue wire
P
6
P (Gray)
6
CONNECTOR (Switch side of male terminal)
RIGHT HANDLEBAR SWITCH
CONNECTOR (Main wire harness side
of female terminal)
W hite/yellow
n
i
White/blue
RIGHT HANDLEBAR SWITCH
CONNECTOR (Main wire harness side
of female terminal)
P (Gray)
6
TCM 33P (Black) CONNECTOR
(Wire side of female terminal)
\
A11
■
i i i
11
r *
A22
/
<§H
P (Gray)
6
.
i