Honda NSA700A DN-1 2009 Service Manual page 376

HFT
Connect an ohmmeter to the swash plate angle sen­
sor A and B terminals.
Inspect the resistance of the swash plate angle sen­
sor shaft groove turning.
Connection: A - B
Standard:
If the resistance is out of the standard value, replace
the swash plate angle sensor.
R EM O VAL
Remove the radiator reserve tank (page 7-17).
Disconnect the swash plate angle sensor 3P connec­
tor.
Remove the bolts.
Remove the swash plate angle sensor and O-ring.
INSTALLATION
Coat a new O-ring with engine oil and install it to
Install the O-ring
the swash plate angle sensor.
w ith o u t tw is t o r
d e form on to the
Install the swash plate angle sensor by aligning the
angle sensor. The
swash plate angle sensor shaft flat surface with
O-ring should be
swash plate angle sensor groove.
fu lly seated to
around o f the angle
sensor surface.
11-100
0 to 1.6 - 2.4 (20 C/68 F)
kQ
3P CONNECTOR
SWASH PLATE
ANGLE SENSOR
Z J ANGLE SENSOR
3PCONNECTOR
(Sensor side of
male terminal)
f t ] n j
h
B
A
SWASH PLATE
ANGLE SENSOR
BOLTS
SWASH PLATE