Output Gear Case Removal; Output Gear Case Installation; Final Drive Shaft - Honda 1984 Shadow VT700C Manual

CRANKSHAFTiTRANSMISSION
OUTPUT GEAR CASE REMOVAL
NOT E:
The following output gear service can be
performed with engine removed from the
frame and without separating the crankcase.
Final drive shaft side bearing holder O'ring
replacement (page 13·4) .
Drive gear seal replacement (page 13·251.
Driven gear shaft bearing replacement
(page
13·26).
Driven gear bearing holder O'ring replace-
ment (page 13·26).
Tooth contact adjustment (page 13·30).
Oilorifice and O·ring inspection and replace·
ment.
Aemove the 8 mm cap nuts and sealing washers.
Remove the output gear case .
Remove the O·ring, dowel pin and shim from the
bearing holder.
NOTE :
I
Take care not to damage the shim.
Remove the oil orifice and clean
it
w i th the com-
pressed air.
OUTPUT GEAR CASE INSTALLA nON
Replace the Q'rings with new ones and install the
output gear case in the reverse order of removal.
13-4
8 mm CAP
AND SEALING WASHERS
DOW' E l PIN
OIL OR IFICE