Honda NSA700A DN-1 2009 Service Manual page 461

FINAL DRIVE
A pply engine oil to the threads and seating surface
of new inner lock nut.
a
Hold the output shaft and tighten a new inner lock
nut to the specified torque using the special tools.
TOOLS:
Shaft holder
Lock nut wrench, 36 x 47.8 mm
Torque slip inspection
attachment
TORQUE:
R efer to torque
w rench reading Actual:
inform ation (page
Indicated:66 N-m (6.7 kgf-m, 49 Ibf ft)
14-4)
Stake the inner lock nut to the output shaft groove.
Stake the outer lock nut to the bearing holder
groove.
Apply grease to the oil seal lip o f a new oil seal and
install it until the ring groove is visible so the stop­
per ring can be installed.
Install the stopper ring into the bearing holder
groove securely.
NOTE:
• Install the stopper ring w ith the chamfered edge
facing the thrust load side.
• Do not reuse worn stopper ring which could eas­
ily spin in the groove.
• Check that the stopper ring is seated in the
groove.
07PAB-0010100
(Not available in
U.S.A.)
07916-MB00002
07KMK-HC50101
73 N m (7.4 kgf-m, 54 Ibf-ft)
ATTACHMENT
LOCK NUT WRENCH H R . INNER LOCK NUT
SHAFT HOLDER
OUTER LOCK NUT
STOPPER
RING