N/D (Neutral/Drive) Clutch - Honda NSA700A DN-1 2009 Service Manual

Connect the fo lowing:
- EOP sensor 3P (Gray) connector
- N/D solenoid valve 2P (Black) connector
- Lock up solenoid valve 2P (Gray) connector
- Oil level sv/itch connectors (Pink/blue and Yel­
low/red wires)
Connect the neutral oil pressure switch wire
tighten the terminal bolt/washer to the specified
torque.
TORQUE: 1.9 N m (0.19 kgf-m, 1.4 Ibf ft)
Install the dust cover.
Install the engine sub harness to the clamps.
Install the following:
- Right side cover (page 3-14)
- Exhaust pipe (page 3-18)
Add the recommended engine oil (page 4-12) and
check that there are no oil leaks.
Warm up the engine and check that the shift indica­
tor is not blinking
check the clutch and transmission operation.

N/D (Neutral/Drive) CLUTCH

REM O VAL
Drain the engine oil (page 4-12).
Remove the right crankcase cover (page 11 -69).
Be careful not to le t
Remove the N/D c|utch assembly.
the NJD clutch drop
when rem oving the
right crankcase
cover.
Remove the washer and prim ary gear.
Test-ride the motorcycle and
DUST COVER
CLAMP
nd
3
CONNECTORS
CLAMP
CONNECTOR
(Yellow/red wire)
N/D CLUTCH
ASSEMBLY
PRIMARY GEAR
WASHER
HFT
BOLT/
WASHER/
WIRE
CONNECTOR
(Pink/blue wire)
11-77