Dtc 44-1 (Eot Sensor Low Voltage) - Honda NSA700A DN-1 2009 Service Manual

HFT
3. Shift Switch Line Open Circuit Inspection
Disconnect the TCM 33P (Black) connector.
Check fo r continuity between the left handlebar
switch 3P (Gray) connector and TCM 33P con­
nector of the wire harness side.
Connection: A21 (W hite/blue) - W hite/blue
TOOL:
Test probe
Is there c o n tin u ity ?
YES
NO
4. Shift Switch Line Short Circuit Inspection
Check for continuity between the left handlebar
switch 3P (Gray) connector terminals of the main
wire harness side and ground.
Connection: W hite/blue - Ground
Is there c o n tin u ity ?
YES
NO
DTC 44-1 (EOT SENSOR LOW
VOLTAGE)
1. EOT Sensor System Inspection
Turn the ignition switch ON and engine stop
s w i t c h " O ' -
Check the EOT sensor w ith the HDS.
Is abo ut 0 V in d ic a te d ?
YES
NO
2. EOT Sensor Inspection
Turn the ignition switch OFF.
Disconnect the EOT sensor 2P connector.
Turn the ignition switch ON.
Check the ECT sensor with the HDS.
Is a b o u t 0 V in d ic a te d ?
YES
NO
11-52
A32 (W hite/yellow) - W hite/yellow
07ZAJ-RDJA110
- GO TO STEP 4.
- • Open circuit in W hite/yellow wire.
• Open circuit in White/blue wire.
W hite/yellow - Ground
- • Short circuit in White/blue wire.
• Short circuit in W hite/yellow wire.
- Replace the TCM w ith a new one, and
recheck (HFT initialization procedure:
page 11-93).
- GO TO STEP 2.
- Intermittent failure.
- GO TO STEP 3.
- Faulty EOT sensor.
LEFT HANDLEBAR SWITCH 3P (Gray)
CONNECTOR (Main wire harness
side of female terminal)
White/blue
White/
yellow
TCM 33P (Black) CONNECTOR
(Wire side of female terminal)
LEFT HANDLEBAR SWITCH 3P (Gray)
CONNECTOR (Main wire harness
side of female terminal)
A21
A32