Honda NSA700A DN-1 2009 Service Manual page 377

Turn the swash plate angle sensor and align the bolt
holes.
Apply locking agent to the bolt threads.
Install and tighten the bolts to the specified torque.
TORQUE: 6 N m (0.61 kgf-m, 4.4 Ibf ft)
Connect the swash plate angle sensor 3P connector.
Install the radiator reserve tank (page 7-17).
Perform the HFT initialization procedure (page 11-
93).
SWASH PLATE ANGLE SENSOR
SHAFT REMOVAL/INSTALLATION
Remove the swash plate angle sensor (page 11-100).
Remove the bolts.
Remove the shaft holder and O-ring.
Remove the swash plate angle sensor shaft and oil
seal.
SWASH PI ATF
ANGLE SENSOR
3P CONNECTOR
BOLTS
SWASH PLATE ANGLE
SENSOR SHAFT
HFT
BOLTS
SHAFT HOLDER
O-RING
11-101