Starter Driven Gear/Starter Clutch Installation - Honda NSA700A DN-1 2009 Service Manual

ALTERNATOR/STARTER CLUTCH
S T A R T E R D R IV E N G E A R
Check the one-way clutch sprag contact surface for
wear or damage.
Measure the driven gear O.D.
S E R V IC E LIMIT: 57.73 mm (2.273 in)
Measure the driven gear I.D.
S E R V IC E LIMIT: 37.10 mm (1.461 in)
STARTER DRIVEN GEAR/STARTER
CLUTCH INSTALLATION
r\am
30 N-m (3.1 kgf-m, 22 Ibf ft)
Clean the one-way clutch and apply engine oil to the
sprag.
Install the one-way clutch into the clutch outer with
it s f la n g e s id e f a c in g t h e
NOTE:
If the spring is removed from the one-way clutch
groove, replace the one-way clutch assembly with a
new one.
12-8
CLUTCH OUTER
FLYWHEEL
flywheel.
ONE-WAY CLUTCH
CLUTCH OUTER
DRIVEN GEAR
ONE-WAY CLUTCH *