Honda NSA700A DN-1 2009 Service Manual page 437

FINAL DRIVE
Remove *.he bolt and retainer lock plate.
Remove the pinion retainer using the special tool.
TOOL:
Retainer wrench
Remove the O-ring and oil seal from the pinion
retainer.
Install the special tools onto the pinion gear shaft
and gear case.
TOOLS:
Pinion puller base
Puller shaft/nut
Pull the pinion gear assembly out of the gear case.
Check ths pinion gear needle bearing in the gear
case for wear or damage.
14-14
LOCK PLATE
07910-MA10100
OIL SEAL
O-RING
PULLER SHAFT
07HMC-MM80110 or
07HMC-MM8011A
(U.S.A. only)
07931-ME40000 or
07931-ME4010B and
07931-HB3020A
(U.S.A. only)
PULLER BASE
RETAINER WRENCH