Honda NSA700A DN-1 2009 Service Manual page 350

HFT
Install and tighten the feed pipe set bolt to the
ified torque.
TORQUE: 18 N m (1.8 kgf-m, 13 Ibf ft)
N/D CLUTCH HYDRAULIC PIPE
Coat a new O-ring with engine oil and install it into
inside of the guide.
Install the guide to the hydraulic pipe.
Coat a new O-ring w ith engine oil and install it to
the guide.
Install the hydraulic pipe by aligning the pipe flange
w ith the right crankcase groove.
Install the snap ring.
11-74
spec-
O-RING
FEED PIPE SET BOLT
GUIDE