Honda NSA700A DN-1 2009 Service Manual page 476

Install and tighten the upper screw first, then tighten
the lower screw.
TORQUE: 4.2 N-m (0.43 kgf-m, 3.1 Ibf-ft)
r Install the master cylinder, holder and bolts.
Install he holder
Align the edge of the master cylinder with the
with its "UP" mark
punch mark o r the handlebar and tighten the upper
facing up.
bolt first, then tighten the lower bolt.
Connect the front brake light switch connectors.
Clean the inside surface of the right handlebar grip
and the outside surface of the throttle pipe.
Apply Honda bond A or equivalent to the inside sur­
face of the handlebar grip and to the outside surface
of the throttle pipe. W ait 3 - 5 minutes and install
the grip.
Rotate the grip for even application of the adhesive.
Mow the adhesive
7
to dry for hour
before using.
Install the left handlebar switch housing, aligning
the locating pin with the hole in the handlebar.
FRONT WHEEL/SUSPENSION/STEERING
MASTER CYLINDER
SCREW (UPPER SIDE)
SCREW (LOWER SIDE) i
PUNCH HOLDER