Honda NSA700A DN-1 2009 Service Manual page 231

ENGINE REMOVAL/INSTALLATION
Connect the oil reserve sensor connectors (Pink/
blue anc Yellow/red wires).
Install the w ire clamp.
Connect the control m o to r 2P (Black) connector and
VS senscr 2P (Black) connector.
Connect the ground cable and tighten the bolt.
Install the w ires to the clamp.
Install the fro n t PAIR check valve and PAIR check
valve cover.
Install and tighten the bolts to the specified torque.
TORQUE: 5.2 N m (0.53 kgf-m, 3.8 Ibf-ft)
Connect the PAIR air supply hose to the rear PAIR
check valve cover.
8-12
OIL RESERVE SENSOR
CONNECTOR
(Pink/blue w ire)
CLAMP
OIL RESERVE SENSOR
CONNECTOR
(Yellow/red w ire)
CONTROL MOTOR 2P (BLACK) CONNECTOR
CLAMP
BOLTS
FRONT PAIR CHECK VALVE
COVER/PAIR CHECK VALVE
PAIR AIR SUPPLY HOSE
GROUND CABLE
VS SENSOR 2P
(BLACK) CONNECTOR
ZWMJny*,
REAR PAIR CHECK
VALVE COVER
m