Eot Sensor - Honda NSA700A DN-1 2009 Service Manual

HFT
Apply grease to the oil seal lip and install it to the
right crankcase.
Coat the swash plate angle sensor shaft with engine
oil and install it by aligning its projection w ith the
swash plate groove.
Coat a new O-ring w ith engine oil and install it to
the shaft holder.
Install the shaft holder and tighten the bolts to the
specified torque.
TORQUE: 12 N m (1.2 kgf-m, 9 Ibf-ft)
Install swash plate angle sensor (page 11-100).

EOT SENSOR

REMOVAL
Remove the radiator reserve tank (page 7-17).
Disconnect the EOT sensor 2P connector.
Remove the EOT sensor and sealing washer.
11-102
OIL SEAL
SHAFT HOLDER
O-RING
SWASH PLATE ANGLE
SENSOR SHAFT
BOLTS