5. TP Sensor Input Voltage Inspection
Check fo r continuity between the engine sub
harness 20P (Black) connector and TCM 33P
(Black) connector of the main wire harness side.
Connection: A31 (Yellow/red) - Yellow/red
TOOL:
Test probe
Is there c o n tin u ity ?
- GO TO STEP
YES
- Open circuit in Yellow/red wire.
NO
6. TP Sensor Output Line Short Circuit Inspection
Check for continuity between the TCM
nector terminal of the wire harness side and
ground.
Connection: A31 (Yellow/red) - Ground
TOOL:
Test probe
Is th ere c o n tin u ity ?
- Short circuit in Yellow/red wire.
YES
NO
- Replace the TCM with
recheck (HFT initialization procedure:
page
11-93)
DTC 8-2 (TP SENSOR HIGH VOLTAGE)
• Before starting inspection, Check for loose or
poor connectors on the TP sensor 3P (Black) con
nector and TCM 33P (Black) connector, then
check the DTC.
1. TP Sensor Inspection
Turn the ignition switch ON and engine stop
switch " O " -
Check the TP sensor with the HDS w ith the PGM-
Fl system.
Is DTC 8-2 o f th e PGM-FI system indicated?
YES
- Inspect the TP sensor trouble shooting
(page
-
)
6
2 1
- Replace the TCM with a new one, and
NO
recheck
(HFT
dure:page 11-93)
07ZAJ-RDJA110
.
6
33P
con
07ZAJ-RDJA110
new one, and
a
initialization
proce-
ENGINE SUB HARNESS 20P (Black)
CONNECTOR (Main wire harness
side of female terminal)
Yellow/red
TCM 33P (Black) CONNECTOR
(Wire side of female term iral)
HFT
i
P
A31
V
11-29