Removing Telephones - Avaya Communication Manager Administrator's Manual

- If the TTI State field is set to voice, then default TTI translations are generated for every
unadministered port on all digital, hybrid, and analog boards.
- If the TTI State field is set to data, then default TTI translations are generated for every
unadministered port on all digital and data line boards in the system.
- Whenever a new digital board is inserted when the system is in TTI Data mode, or when
a digital, hybrid, or analog board is inserted when the system is in TTI Voice mode, the
unadministered ports on the board become TTI ports.
- When TTI is deactivated, all translation for the TTI ports are removed in the system; the
ports return to an unadministered state.

Removing Telephones

Before you physically remove a telephone from your system, check the telephone's status,
remove it from any group or usage lists, and then delete it from the system's memory.
For example, to remove a telephone at extension 1234:
1. Type status station 1234. Press Enter.
The General Status screen appears.
2. Make sure that the telephone:
is plugged into the jack
●
is idle (not making or receiving calls)
●
has no messages waiting
●
has no active buttons (such as Send All Calls or Call Forwarding)
●
3. Type list groups-of-extension 1234. Press Enter.
The Extension Group Membership screen shows whether the extension is a member of
any groups on the system.
4. Press Cancel.
5. If the extension belongs to a group, access the group screen and delete the extension from
that group.
For example, if extension 1234 belongs to pickup group 2, type change pickup group 2
and delete the extension from the list.
6. Type list usage extension 1234. Press Enter.
The Usage screen shows where the extension is used in the system.
7. Press Cancel.
Removing Telephones
Issue 2.1 May 2006 99