Show Cdp Interface - Cisco Nexus 5500 Series Command Reference Manual

show cdp interface

show cdp interface
To display the Cisco Discovery Protocol (CDP) parameters for an interface, use the show cdp interface
command.
Syntax Description ethernet slot/[QSFP-module/]port
mgmt mgmt-num
Command Default None
Command Modes EXEC mode
Command History Release
6.0(2)N1(1)
5.2(1)N1(1)
Examples This example shows how to display the CDP parameters for an Ethernet interface:
switch# show cdp interface ethernet 1/30
Ethernet1/30 is down
switch#
This example shows how to display the CDP parameters for a management interface:
switch# show cdp interface mgmt 0
mgmt0 is up
switch#
Related Commands Command
cdp
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
1270
show cdp interface {ethernet slot/[QSFP-module/]port | mgmt mgmt-num}
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
CDP enabled on interface
Refresh time is 60 seconds
Hold time is 180 seconds
CDP enabled on interface
Refresh time is 60 seconds
Hold time is 180 seconds
Description
Enables CDP on the switch.
Specifies an Ethernet interface. The slot number is from 1 to 255.
The QSFP-module number is from 1 to 4. The port number is
from 1 to 128.
The QSFP-module number applies only to the QSFP+
Note
Generic Expansion Module (GEM).
Specifies a management interface. The management interface
number is 0.
Chapter Show Commands
OL-27880-02