RADIUS Commands
OL-32830-01 Command Line Interface Reference Guide
40.6 radius-server timeout
Use the radius-server timeout Global Configuration mode command to set how
long the device waits for a server host to reply. Use the no form of this command to
restore the default configuration.
Syntax
radius-server timeout
no radius-server timeout
Parameters
•
timeout-seconds
timeout
1–30).
Default Configuration
The default timeout value is 3 seconds.
Command Mode
Global Configuration mode
Example
The following example sets the timeout interval on all RADIUS servers to 5
seconds.
switchxxxxxx(config)#
40.7 radius-server deadtime
Use the radius-server deadtime Global Configuration mode command to
configure how long unavailable RADIUS servers are skipped over by transaction
requests. This improves RADIUS response time when servers are unavailable. Use
the no form of this command to restore the default configuration.
Syntax
radius-server deadtime
timeout-seconds
—Specifies the timeout value in seconds. (Range:
radius-server timeout
deadtime
5
40
794