Flowcontrol - Cisco 300 Series Cli Manual

Ethernet Configuration Commands
OL-32830-01 Command Line Interface Reference Guide
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example enables auto-negotiation on gi 1 1.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

18.9 flowcontrol

To configure the Flow Control on a given interface, use the flowcontrol Interface
(Ethernet, Port Channel) Configuration mode command. To disable Flow Control,
use the no form of this command.
Syntax
{auto | on | off}
flowcontrol
no flowcontrol
Parameters
•
auto—Specifies auto-negotiation of Flow Control.
•
on—Enables Flow Control.
•
off—Disables Flow Control.
Default Configuration
Flow control is Disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
Use the negotiation command to enable flow control auto.
interface gi11
negotiation
18
396