Storm-Control Flowcontrol - Cisco Small Business 200 Series User Manual

Port Management
Flow Control and Storm Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference
Default
No threshold is configured.
Command Modes
Interface Config
Global Config
Related Commands
Command
storm-control
broadcast
storm-control
broadcast level
show storm-
control

storm-control flowcontrol

Use this command to enable 802.3x flow control on all ports on the switch or on an
individual port.
For half-duplex ports, backpressure is also enabled. If a traffic jam occurs, the
switch sends collision frames on the port; transmitting stations are signaled to
resend the packets. Flow control is not applicable in this case.
Use the no form of command to disable storm-control flow control globally on the
switch or on a specific port.
storm-control flowcontrol
no storm-control flowcontrol
Default
Flow control is disabled on all port.
Command Modes
Global Config
Interface Config
Description
Enables broadcast storm recovery mode for an interface
or all interfaces.
Configures the broadcast storm recovery threshold for an
interface or all interfaces.
Shows storm control configuration on a port or on all ports.
3
191