MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation
MX2020 CB-RE Description
28
Reset button—Reboots the Routing Engine on the CB-RE when pressed.
Online/Offline button—Takes the Routing Engine on the CB-RE online or offline when
pressed.
LEDs—Provide status of the Routing Engine on the CB-RE.
RE-MX2000-1800x4 CB-RE Boot Sequence
The router is shipped with the Junos OS preinstalled on the CB-RE. There are three copies
of software:
One copy on the CompactFlash card in the Routing Engine.
One copy on a USB flash drive that can be inserted into the slot on the CB-RE faceplate.
The Routing Engine interface boots from the storage media in this order: the USB device
(if present), then the CompactFlash card, then the LAN. Normally, the router boots from
the copy of the software on the CompactFlash card.
RJ-45 Connector Pinouts for MX Series CB-RE AUX and CONSOLE Ports
RJ-45 Connector Pinouts for an MX Series CB-RE MANAGEMENT Port
Removing an MX2020 CB-RE on page 232
MX2020 Host Subsystem Description on page 25
Figure 12 on page 28
shows the Control Board and Routing Engine
(CB-RE)—RE-MX2000-1800x4.
Table 8 on page 28
describes the Control Board and Routing Engine
(CB-RE)—RE-MX2000-1800x4 ports.
Figure 12: RE-MX2000-1800x4 CB-RE Front View
1
2
3
4
5
AUX
CONSOLE
MGMT
USB
RESET
Table 8: Components on the RE-MX2000-1800x4
Function No.
1
2
6
ONLINE
OFFLINE
10
9
Label
Description
This port is used to connect a laptop,
AUX
modem, or other auxiliary unit.
This port is used to configure the
CONSOLE
MX2020 router.
7
8
Copyright © 2013, Juniper Networks, Inc.