Table 22: RE-S-X6-128G Routing Engine LEDs (continued)
Label
Color
Green
DISK1
-
DISK2
Green
-
Green
OK/FAIL
Yellow
MASTER
Blue
See Also
MX240 Routing Engine LEDs
See Also
Copyright © 2019, Juniper Networks, Inc.
State
Blinking
Off
Blinking
Off
On steadily
On steadily
On steadily
RE-S-X6-128G Routing Engine Boot Sequence
Booting in a RE-S-X6-128G Routing Engine follows this sequence—the USB device, SSD1,
SSD2, LAN. SSD1 is the primary boot device. The boot sequence is tried twice for SSD1
and SSD2.
Supported Routing Engines by Router on page 78
Routing Engine Specifications on page 71
Each Routing Engine has four LEDs that indicate its status. The LEDs, labeled
,
, and
, are located directly on the faceplate of the Routing Engine.
HDD
ONLINE
FAIL
Table 23 on page 69
describes the functions of the Routing Engine LEDs.
Table 23: Routing Engine LEDs
Label
Color
Blue
MASTER
Green
HDD
Green
ONLINE
FAIL
Red
Replacing an MX240 Routing Engine on page 230
Description
Indicates presence of disk activity.
There is no disk activity.
Indicates presence of disk activity.
There is no disk activity.
Routing Engine is powering up.
Routing Engine is not powering up, which indicates failure.
This Routing Engine is the Master Routing Engine.
State
Description
On steadily
Routing Engine is the master.
Blinking
Indicates activity on the hard disk drive.
Blinking
Routing Engine is transitioning online.
On steadily
Routing Engine is functioning normally.
On steadily
Routing Engine has failed.
Chapter 1: Overview
,
MASTER
69