Re-S-X6-128G Routing Engine Boot Sequence; Routing Engine Specifications - Juniper MX480 Hardware Manual

RE-S-X6-128G Routing Engine Boot Sequence

Booting in a RE-S-X6-128G Routing Engine follows this sequence—the USB device, SSD1, SSD2, LAN.
SSD1 is the primary boot device. The boot sequence is tried twice for SSD1 and SSD2.
SEE ALSO
Supported Routing Engines by Router | 89

Routing Engine Specifications | 81

Routing Engine Specifications

Table 29 on page 81 lists the current specifications for Routing Engines supported on M Series, MX Series,
and T Series routers. Table 30 on page 86
VMHost support. Table 31 on page 88
NOTE: For a list of the routing engines that are supported on the M Series, MX Series, T Series,
and PTX routers, see
NOTE: For information about PTX Series Routing Engine specifications, see Routing Engines
Supported on PTX Series Routers.
Table 29: Routing Engine Specifications
Routing Engine
RE-400-768
RE-A-1000-2048
lists the hardware specifications of the Routing Engines with
lists the specifications for end-of-life Routing Engines.
"Supported Routing Engines by Router" on page
Connection
Processor Memory to PFEs
400-MHz 768 MB Fast
Celeron Ethernet
1.0-GHz 2048 MB Gigabit
Pentium Ethernet
89.
Disk Media
40 GB 1 GB
hard CompactFlash
disk card
40 GB 1 GB
hard CompactFlash
disk card
81
First Switch
Junos OS Control
Support Board
9.0 –
8.1 –