RE-S-X6-128G Routing Engine Boot Sequence
Booting in a RE-S-X6-128G Routing Engine follows this sequence—the USB device, SSD1, SSD2, LAN.
SSD1 is the primary boot device. The boot sequence is tried twice for SSD1 and SSD2.
SEE ALSO
Supported Routing Engines by Router | 92
Routing Engine Specifications | 84
MX240 Routing Engine LEDs
Each Routing Engine has four LEDs that indicate its status. The LEDs, labeled MASTER, HDD, ONLINE,
and FAIL, are located directly on the faceplate of the Routing Engine.
functions of the Routing Engine LEDs.
Table 23: Routing Engine LEDs
Label
Color
MASTER
Blue
HDD
Green
ONLINE
Green
FAIL
Red
SEE ALSO
Replacing an MX240 Routing Engine | 288
State
Description
On
Routing Engine is the master.
steadily
Blinking
Indicates activity on the hard disk drive.
Blinking
Routing Engine is transitioning online.
On
Routing Engine is functioning normally.
steadily
On
Routing Engine has failed.
steadily
Table 23 on page 81
describes the
81