MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation
Installing an MX2020 Dual-Wide MIC
306
Figure 154: Installing a DC Power Supply Module
MX2020 DC Power Supply Module Description on page 96
Removing an MX2020 DC Power Supply Module on page 454
To install a dual-wide MIC:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the septum, if necessary (see
2.
Place the MPC on a flat surface. If necessary, remove the MPC from the ADC as
a.
described in
"Removing an MX2020 MPC from the Adapter Card" on page
Remove the four screws labeled
b.
Remove the two screws labeled
c.
Slide the septum toward you and out of the MPC.
d.
Figure 155 on page
307):
S
on the bottom of the MPC.
on the top of the MPC.
S
Copyright © 2015, Juniper Networks, Inc.
487.