Installing An Mx240 Dual-Wide Mic; Figure 119: Removing The Septum - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide
See Also

Installing an MX240 Dual-Wide MIC

280
For further description of the output from the command, see the
MX240 Modular Interface Card (MIC) Description on page 116
MX240 Modular Interface Card (MIC) LEDs on page 124
Troubleshooting the MX240 MICs on page 354
To install a dual-wide MIC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Remove the septum, if necessary (see
2.
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in "Removing an MX240 MPC" on page
Remove the four screws labeled
b.
Remove the two screws labeled
c.
Slide the septum towards you and out of the MPC.
d.
Store the septum and screws for later use.
e.
Install the MPC as described in
f.

Figure 119: Removing the Septum

Remove four screws
on bottom.
If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
3.
on the faceplate. Install a cap if necessary.
Pull the ejector lever above both MIC slots away from the router.
4.
Figure 120 on page 282):
Figure 119 on page
284).
S on the bottom of the MPC.
S on the top of the MPC.
"Installing an MX240 MPC" on page
Remove two
screws on top.
Slide septum
forward.
MPC
Copyright © 2019, Juniper Networks, Inc.
.
CLI Explorer
280):
286.