Installing An Mx240 Dual-Wide Mic; Figure 98: Removing The Septum - Juniper MX240 Hardware Manual

Related
Documentation

Installing an MX240 Dual-Wide MIC

Copyright © 2017, Juniper Networks, Inc.
MX240 Modular Port Concentrator (MPC) Description on page 77
Maintaining MX240 MPCs on page 393
Removing an MX240 MPC on page 311
Installing an MX240 MIC on page 240
MX240 MPC Serial Number Label on page 426
Preventing Electrostatic Discharge Damage to an MX240 Router on page 444
To install a dual-wide MIC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Remove the septum, if necessary (see
2.
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in "Removing an MX240 MPC" on page
Remove the four screws labeled
b.
Remove the two screws labeled
c.
Slide the septum towards you and out of the MPC.
d.
Store the septum and screws for later use.
e.
Install the MPC as described in
f.

Figure 98: Removing the Septum

Remove four screws
on bottom.
If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
3.
on the faceplate. Install a cap if necessary.
Figure 99 on page 247):
Figure 98 on page
311).
on the bottom of the MPC.
S
on the top of the MPC.
S
"Installing an MX240 MPC" on page
Remove two
screws on top.
Slide septum
forward.
MPC
Chapter 21: Installing Components
245):
243.
245